So its been pretty cold outside and my shop is neither insulated nor heated so I have not been out there to much. But with the minimal time I have spent I managed to repin the fuselage side wing root CPC. I also finished the wing side CPC connectors.
After that I started to finish up the wire routing and the clamping of wire bundles with the goal of finishing up everything aft of the main wing spar so that I can put the rear floors in. While doing that I noticed a crack in the rear floor rib. I stop drilled the crack and am going to put a patch over the rib. I have taken some pictures and will send them to technical to see if they concur with my fix. If I need to replace the rib it wont be that bad. But the worst part will be reruning the wires, cables, and tubes that go thru it.